Powerspark Electronic Ignition Kit (Positive Earth) for Lucas 22D6 & 25D6 Distributor K1PP & R4-Powerspark

K1PP & R4 - Powerspark Electronic Ignition Kit (Positive Earth) for Lucas 22D6 & 25D6 Distributor

This Powerspark Electronic Ignition Kit is designed to replace the points and condenser inside a Lucas 22D6 & 25D6 Distributor.

Use the pdf Download icon to see the Standard Installation Instructions for POSITIVE Earth Vehicle Installations 

The Lucas 22D6 & 25D6 Distributor was fitted to a wide variety of 6 Cyl vehicles including Aston Martin, Austin Healey, Jaguar, Land Rover, MG, Triumph, TVR and many more.

Powerspark electronic ignition conversion kit to suit Lucas 22d6 & 25d6 distributors.

Suits many 6 cylinder British cars approx 1960 to 1974.

Jaguar, Humber, Aston Martin, Ford Zephyr etc.

It is a complete kit to convert your car to electronic ignition, including a Powermax moulded Red Rotor Arm.

Fitting is easy and instructions are included with the packaging, as well as available online.

Electronic ignition will give your classic car better starting and smoother running.

Please Note - This Powerspark Electronic Ignition Kit is for positive earth vehicles only.

This Powerspark Electronic Ignition Kit contains everything needed to convert your car from points & condenser to electronic ignition.

Fitting is easy and instructions are included with the packaging, as well as available online and in the video below.

Benefits:

- Easy to install
- Replaces troublesome points and condenser
- No visible difference in your engine bay
- Improved starting
- Improved performance
- Improved durability
- Maintenance free

Requirements:

- To be used with a coil resistance above 1.5 ohms only
-  MUST be used with silicone HT leads, NOT COPPER. Click here to browse our range of HT leads.

Powerspark Electronic Ignition explained in more detail:

The kit uses a simple magnetic trigger and optimises dwell to provide a reliable and consistent spark across the rev range. It is easy to install and maintenance free.

Each kit comprises a baseplate with electronic module, trigger ring and all wiring. The new electronic baseplate mounts exactly where the points and condenser baseplate sat. The kit connects directly to the coil using the wires provided, red to the positive side and black to the negative side. The ignition kit will automatically shut down if the ignition is left switched on without the engine running to prevent component damage.

Powerspark Electronic Ignition Kits are designed to work with a coil resistance above 1.5 ohms, typically 3.0 ohms. Some performance coils operate at a lower resistance and will need the High Energy electronic ignition kit.

Full fitting instructions are included with your kit,. make sure you read them The Fitting of a positive earth Kit demands some care.