Lucas 12V Ignition Coil 3.0 ohm (with screw-in HT connection) DLB100LUCAS

Red Watch

Lucas 12V Ignition Coil 12v  (with screw-in HT connection)   DLB100LUCAS
Lucas GCL101 ignition coil. 
DLB100 
Replaces Lucas HA12 coils with screwed-in HT lead 
Rated at 12volt  
Standard Lucas DLB100 12V Ignition coil with older style screw terminal (acorn) HT connection.
Low tension connections are 5mm studs which come complete with spade terminal connections (removable).
Standard type 12 volt Lucas coil with a push-in centre lead.
Supplied with the mounting bracket and ready to fit.
Wires attached via 5mm ring terminals, or adaptors (included) to take Lucar terminals.
Overall height:  150mm
Body height:      105mm
Diameter:           50mm

Factory Resistance Rating:
Secondary Coil Min (kohms)   6.12 
Secondary Coil Max (kohms)   7.48
Primary Resistance Min Ohms   3.18
Primary Resistance Max Ohms    3.73

Body diameter 55mm with a cap diameter of approximately 65mm. Total length approximately 150mm (excluding acorn).
Suitable brass washers for terminating the HT cable when using with acorn type connectors . 
Please note that the acorns are not supplied with the coil and can be found on the website. (Please ask if you require an acorn.)

As used typically on the following vehicles:
Austin
Bristol
Daimler
Commer
Hillman
Humber
Jaguar
Land-rover
Morris
Classic Mini
MGB roadster
MGB GT
MG
Standard
Triumph
Wolseley
Riley
Singer
Sunbeam
Rover etc

Alternate Part Numbers:
DLB100HQLUCAS
GCL101
GCL101LUCAS 
HA12